Hello there, is this your first visit?
Register

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Page 2 of 2 FirstFirst 12
Results 11 to 13 of 13
  1. #11
    Join Date
    Jan 2009
    Location
    arizona in meadview
    Posts
    84
    i updated my cooler lines to 3/8", first i purchased some fittings to screw in the trans from Fedhill part # AD6br, then i drilled out the hole to 5/16" dia. then counter sunk the inner ends to improve flow.

  2. #12
    Join Date
    May 2009
    Location
    White Lake Michigan
    Posts
    77
    Quote Originally Posted by C7Z View Post

    The link doesn't work.
    Where can I get the info? I need the fittings that go on the lines, I have the fittings in the trans...

    Danford1

  3. #13
    Join Date
    May 2009
    Location
    White Lake Michigan
    Posts
    77
    Quote Originally Posted by danford1 View Post
    The link doesn't work.
    Where can I get the info? I need the fittings that go on the lines, I have the fittings in the trans...

    Danford1
    The link works now but all it says is 1/4" size. No part numbers are given

    Danford1

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •