Hello there, is this your first visit?
Register

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Results 1 to 5 of 5
  1. #1
    Join Date
    Jun 2013
    Location
    North Georgia
    Posts
    52

    Question Attn Dan: stator lube upgrades.

    I miss understood the instructions about enlarging OWC feed hole in the stator. I enlarged ALL 3 holes in the stator, is that a bad thing?

  2. #2
    Join Date
    Apr 2006
    Location
    KCMO
    Posts
    9,126
    you will probably be fine, what vb are you using?

  3. #3
    Join Date
    Jun 2013
    Location
    North Georgia
    Posts
    52
    Quote Originally Posted by SilverFox View Post
    you will probably be fine, what vb are you using?
    that's a relief.

    using a stock valve body with the separator plate drilled to Jerry's specifications on TCCOA. also using Sonnax updated pressure regulator valve, boost valve and OD servo regulator valve.
    Last edited by 88grandmarq; 06-18-2013 at 10:21 AM.

  4. #4
    Join Date
    Apr 2006
    Location
    KCMO
    Posts
    9,126
    you'll be good

  5. #5
    Join Date
    Nov 2016
    Location
    hemet,calif
    Posts
    1
    thats good because i did the same thing drilled out all 3 holes to 3/32------------i was sweating it till i read this------------not stressing anymore thanks

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •