Hello there, is this your first visit?
Register

If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below.

Results 1 to 4 of 4
  1. #1
    Join Date
    Jan 2018
    Location
    Cypress, TX
    Posts
    12

    trans tabs on 4R70w

    been searching thru threads about the 4R70W swap and have seen several saying there needs to be tabs cut off for clearance but I have yet to see something indicating which tabs it is referring to.

  2. #2
    Join Date
    Apr 2010
    Location
    caryville, Tn
    Posts
    651
    here are all the places i removed...

    111_6206 by boostdcoupe, on Flickr

    111_6210 by boostdcoupe, on Flickr

    111_6211 by boostdcoupe, on Flickr

    111_6212 by boostdcoupe, on Flickr
    76'ish F100 short bed, 393, AOD, etc...

  3. #3
    Join Date
    Apr 2010
    Location
    caryville, Tn
    Posts
    651
    mine was being installed in a fox coupe, im not sure what your car is. but it fit fine in my coupe after removing those places.

    NOTE: in my first pic, ive got a finger on two places, only the rear one was removed. this allowed me to use my stock coupe AOD shifter cable.
    Last edited by Boostdcoupe; 01-31-2018 at 07:22 PM.
    76'ish F100 short bed, 393, AOD, etc...

  4. #4
    Join Date
    Apr 2018
    Location
    Ga
    Posts
    10
    My buddy did the same thing to make things fit.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •