A few C-4 questions....

[BLACK COUPE]

As a few of you know I'm doing a t-5 to c-4 swap in my coupe but I have a few questions I've run into here they are

1. What tranny mount do I use.

2. Do I have to do any work to my block/bell plate to get it to work? If so what?

3. How do I disable the clutch safty switch?

4. What fittings do I need the run the cooler lines to the tranny. What lines should I use without breaking the bank?

This is all I have right now I'm sure there'll be more later. Thanks.
Oh here's one more, What tranny fluid to run. I know royal purple and red line, but I need something I can get off the shelf at a local parts place.

[modo]

As a few of you know I'm doing a t-5 to c-4 swap in my coupe but I have a few questions I've run into here they are

1. What tranny mount do I use.

2. Do I have to do any work to my block/bell plate to get it to work? If so what?

3. How do I disable the clutch safty switch?

4. What fittings do I need the run the cooler lines to the tranny. What lines should I use without breaking the bank?

This is all I have right now I'm sure there'll be more later. Thanks.
Oh here's one more, What tranny fluid to run. I know royal purple and red line, but I need something I can get off the shelf at a local parts place.

1) standard mount, upgrading it would be a plus though (poly)

2) you would have to do a lot of cutting to the block plate and i wouldn't since it plays a important role in shimming the converter to the front pump of the transmission... you can pick them up for about 40 bucks from all the transmission places. i picked mine up at trans-specialties in aston, pa


3) goto a junk yard and find some aod cars... you will need two factory jumpers. look under the dash where the clutch quadrant would be and the jumpers will be there. you need one for the clutch nss which is on the quadrant and you will need another for the cruise control (if you care) which is right next to the gas pedal.

4) i used -6an fittings and lines i had left over from doing my fuel system. thats the easiest

[BLACK COUPE]

Do I use an aod block/bell plate?

[2MUCHBOOST]

No you need a C4 plate. Or take a AOD one and cut the shit out of it.

[K*A*B]

i stopped using the plate years ago , so far i have not ran into one single problem